An air receiver tank is a pressure vessel in a compressed-air system that temporarily stores compressed air, providing energy buffering, pressure and flow stabilization, preliminary condensate separation, residual-heat cooling, and safety redundancy.

A pipeline filter is installed in compressed-air or liquid transport lines and is widely used in compressor-station after-treatment, process-fluid, steam, and industrial water-supply or drainage systems. By efficiently removing particles and oil mist with minimal pressure drop, it provides a clean, stable medium to downstream equipment, markedly improving equipment reliability, product quality, and energy efficiency. Consequently, pipeline filters are indispensable safety and quality-assurance components in compressed-air and fluid piping systems. The pipeline filter can filter out impurities such as dirt, oil, water, etc. Through the three-stage precision filtration of compressed air filter A, B, C, from coarse to fine, it can effectively remove 99.9% of impurities.

BPM PM VSD Screw Compressor 10-100HP，integrates the motor shaft directly with the screw rotors, eliminating couplings and belt wear and delivering nearly 100 % mechanical efficiency. The BPM series thus offers the best cost-performance solution for users who need continuous energy savings, stable pressure, and high reliability.

Skid-Mounted Air Compressor, 30HP-100HP, the compressor, refrigerated dryer, precision filters, and air receiver are all pre-piped and pre-wired on a single base. Once delivered, you only need to hook up power and the air line for it to run. After a complete Factory Acceptance Test (FAT) at the plant, on-site start-up and commissioning take just 2–4 hours before compressed air is ready. Compact structure and space saving. Since the skid-mounted device adopts intensive layout and compact layout, it can greatly reduce the land occupation, which is of great significance for the oil and gas industry, which occupies a large amount of land. Convenient demolition and easy to move. The skid-mounted device is easy to disassemble and assemble. Indoor operation and cost saving. Most of the work is completed in the factory. On-site installation only requires installing the skid to the foundation, connecting the skid inlet and outlet pipelines, and wiring some electrical instruments, which greatly reduces the on-site workload and installation time.

The booster air compressor is the best solution for large-flow medium-pressure air systems, and can boost the 0.8~1.2MPa air source to 3.0~5.0Mpa (maximum processing flow can reach 40.0m³/min). The latest optimized main engine screw profile and specially designed medium-pressure main engine make the product performance more excellent The full range of permanent magnet frequency conversion control, smooth start-up, and small impact on the power grid Two-stage or three-stage screw main engine compression, small size, light weight, small space occupation Its low and medium pressure systems are independent of each other, easy to combine, and economical and reliable in operation The full range of matching air cooling system, no need to install cooling water tower No need to install foundation, easy installation, simple and convenient maintenance Comes with high-efficiency refrigerated dryer, the dew point of the discharged compressed air is about 5~7℃

Oxygen generators and nitrogen generators are complete systems that separate ambient air into a single or high-concentration component—O₂ or N₂. They normally comprise an air compression and purification stage, a separation module, a product-gas buffer tank, and an automated control unit. Installed at the point of use, they supply gas continuously on site, replacing conventional cylinders, liquid tanker deliveries, or centralized cryogenic air-separation plants.